Mixing for vinyl master

For general questions or discussion of Auria.

Moderators: Corey W, Rim

Post Reply
Renfield
Expert
Posts: 56
Joined: Sat Dec 20, 2014 10:27 am

Mixing for vinyl master

Post by Renfield » Fri May 05, 2017 4:41 am

Hi,

I'm planning to send a couple of songs for a vinyl mastering. Where do I cut the treble and the bass? I want to avoid the risk of distortion and a jumping needle.

User avatar
Anthony Alves
Expert
Posts: 1201
Joined: Sat Mar 10, 2012 9:52 am

Re: Mixing for vinyl master

Post by Anthony Alves » Fri May 05, 2017 5:31 am

I would contact the mastering studio who will be cutting your vinyl record because that is the process of the mastering desk to cut vinyl records. These HP and LP filters are applied at the mastering desk. But if for some reason a vinyl mastering studio doent have this facility, which I doubt, you can simply apply a ProQ at the final stage and use a Low Cut and High Cut to reduce those frquencies. If your doing the mastering for them then you must find out from them what frequencies to cut as that is dependant on the vinyl cutting lathe that they are using. Cheers and good luck.

Renfield
Expert
Posts: 56
Joined: Sat Dec 20, 2014 10:27 am

Re: Mixing for vinyl master

Post by Renfield » Fri May 05, 2017 7:31 am

Thanks for you answer!

Post Reply

Who is online

Users browsing this forum: Baidu [Spider], Bing [Bot] and 5 guests