iOS 7.1 Update

[Normhart]

Thanks Rim. I do have an interface (Griffin Studioconnect) that I haven't tried since installing 7.1 - I will post again as soon as I get a chance to try it. However, rather than go back to 7.06 (can I do that? I didn't know I could roll back to the previous version), I prefer to stay with the latest ios as much as possible. If the problems goes away with the audio interface, I guess I'm all set (although it still would be nice the have you guys resolve it on your end). Thanks again!

[Auratech]

Tried to create a 96K project Zoom H6 unplugged. Fail.
Even the virtual keyboard's sounds are missing during the name edit. After "return" - quitting.
2. try
Zoom H6 plugged - OK.
Created new 96K projekt- OK.
Edit, monitor...OK. Recording some tracks ..OK
Unplugged the Zoom - and try replay the 96K project - without ZoomH6 - quit

[Phil999]

Phil,

Have you tried a 96K project with all audio interfaces unplugged? This seems to be an issue with iOS7.1

Rim

no. I have heard of problems without interface, so I did not try. 44.1 and 96 kHz projects with interface is fine, that's all I can say, sorry. Maybe I should add that I don't see any sense in 96 kHz projects using the built-in microphone.

[Normhart]

Tried it with the interface. No luck. It seemed ok at first (didn't crash out immediately like before) but eventually started showing the same problems. I guess I'll just have to stay away from 96kHZfor the time being. It works fine with 44.1kHZ and 48kHZ.

[Rim]

96K should work fine by plugging in any interface that supports 96K, and leaving it plugged in while using that project.

I've just found a way to fix this, and will be posting an expedited update very soon.

Rim

[Normhart]

96K should work fine by plugging in any interface that supports 96K, ,and leaving it plugged in while using that project.

I've just found a way to fix this, and will be posting an expedited update very soon.

Rim

That explains it. I don't think the Studioconnect is capable of 96k. They have one called a Studioconnect HD that I believe does. I guess it'll have to be 44.1/48 for now. Actually, my desktop runs at 24/96. I guess I'll use that for any 96k projects until I can upgrade the Studioconnect. Good to hear that you have a fix coming,though.

Addendum: I checked that the Studioconnect I have is limited to 24-bit 48kHz which is probably as high as I'd want to go anyway in a practical sense.

[Phil999]

that is correct. I have another interface that has a fixed sampling rate of 44.1 kHz, and with that one I can only do Auria project at 44.1 kHz. Which is enough for common line-in and middle-class microphones.

[Normhart]

Actually I'm quite satisfied with 44.1 as I have never felt the need to go higher - even with my desktop DAW which can go into the higher sample rates.

[Tarekith]

Ditto.