For Auria users to share their creativity!
5 posts • Page 1 of 1
It may be the processing or the room in which the choir was recorded in or even the mic placement. Reverb on a choir should be very little as the various frequencies can get over hyped with the effect. Also you may have compressed too hot as there is a lack of dynamic range. Try seperating everything and try to come up with a clean track with a good blended mix using only eq. Once you have a nice mix, continue with a slight compression followed by some small room reverb. Try to create a wider stero spread using your ProQ's mid/side mode and push the side channel up a bit. I really couldn't make out the words very well and it would appear that the message in this song is important to you and it's listeners so intelegible vocals is very important especially in a vocal only recording. Cheers and hope this helps.
Who is online
Users browsing this forum: No registered users and 1 guest