Help with H6 Signal

For topics specifically about audio interfaces (USB, MFi, Camera Connection Kit)

Moderators: Corey W, Rim

Post Reply
dwamusic
New Member
Posts: 2
Joined: Tue Oct 08, 2013 12:55 pm

Help with H6 Signal

Post by dwamusic » Tue Oct 08, 2013 1:00 pm

Hi,

Can someone walk through the steps of getting a signal out of the new Zoom H6 into Auria?

I have had no problems at all with my PreSonus 1818 VSL. However, I'm having a hard time getting the H6 to function. Currently, it is playing the part of merely being a speaker for whatever iPad sounds are produced, but I can't get it to take a recording input. Help please!!

Many thanks!!

Auratech
Expert
Posts: 50
Joined: Sun Mar 17, 2013 10:21 am
Location: Hungary, Győr
Contact:

Re: Help with H6 Signal

Post by Auratech » Thu Oct 10, 2013 3:57 am

dwamusic wrote:Hi,

Can someone walk through the steps of getting a signal out of the new Zoom H6 into Auria?

I have had no problems at all with my PreSonus 1818 VSL. However, I'm having a hard time getting the H6 to function. Currently, it is playing the part of merely being a speaker for whatever iPad sounds are produced, but I can't get it to take a recording input. Help please!!

Many thanks!!
- Plug the mic module XY or MS mic module in.
- Turn Zoom H6 on
- Press L-R to record enable
- Adjust some gain on mic module..set to 7...
- Press menu
- Navigate to usb menu and press the navigate button once again.
- Navigate to Audio Interface and press the navigate button once again to select.
- Set to Stereo mix (only 16bit/44.1kHz in-out) or multitrack (24 bit/96 Khz - 6 track) We do prefer multitrack now!
- Select Multitrack and then select PC/MAC using Battery Power.
This is a must for iPad and CCK to work properly.
Zoom Ready to rock!

- iPad Setting: Setings /-Security/- Mic for Auria to enable (ios7)

- Connect the Zoom H6 usb to iPad CCK and plug into iPad.
- Wait about 5 sec
- Start Auria
- Touch - Menu/ Input matix set track one to 1 and track 2 to 2
- Press track 1-2 torecord enable on mixer. Adjust pan to l-R.
- At last You see the input signal from H6
- Record some noises.
- Press the L-R track off on the H6 not to disturb your monitoring.
- The playback comes default from Zoom H6.
You can monitor your recording in Zoom H6 using the headphone/Line out plug.

Ready.
My rover Studio: iPad Air2-64Gb, Auria, Zoom H6, 2xRode Nt1, 2x Rode Nt55,
DT-770PRO, XMS-disc-(Jecklin), Ruinvo-panasonic USB Power pack,
Home: Rebuilt BEAG Hec45 Active Studio Monitors, i7-PC-Samplitude, IK-Multimedia ARC-2

dwamusic
New Member
Posts: 2
Joined: Tue Oct 08, 2013 12:55 pm

Re: Help with H6 Signal

Post by dwamusic » Thu Oct 10, 2013 9:49 am

Thanks so much for the clear instruction!!
We're rockin' and rollin'!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests