How route signals in Auria Pro?

For general questions or discussion of Auria.

Moderators: Corey W, Rim

Post Reply
Posts: 8
Joined: Sat Nov 28, 2015 8:59 pm

How route signals in Auria Pro?

Post by Xielvas » Wed Dec 05, 2018 4:42 pm

I I’m ashamed, I’ve had a Auria Pro for year and a half and have hardly used it because I got confused on how to do it.

What I’m trying to is this:

Apogee Jam signal sent to Auria limiter to remove 2 dB peaks of dry guitar signal with built in limiter (if possible)
Have that signal sent to FF Pro-Q2 (low cut/high cut)
Have the above signal sent to ToneStack or JamUp
Have ToneStack / JamUp signal sent to FF Pro-Q2 then out to Master output.

Probably easy for mostly you, but I haven’t used it much.
When overloud THM is back how would I do the above with that as well?

I would move this but not sure how to remove it from here after

Post Reply

Who is online

Users browsing this forum: No registered users and 15 guests