Effects chain issue
Effects chain issue
Whenever I add effects in the chain(pro q, or proc2) , when I set it to say vocals preset, and go back in later the bypass light is on? However I believe it's still processing even though the button is on. Also, when I do set a preset and go back in ( say vocal preset in proq2) the preset is still setup right but the preset says "default" not vocal. This is a problem because I'm recording 10-15 vocal tracks in a session, and then I go back and edit but I need the effects to match up and I shouldn't have to remember. Same goes for pro c2. I'll set pro c2 at vocal preset "something for nothing Dax" , when I go back in later it says default
Re: Effects chain issue
Auria doesn't have a bypass button anymore. The button was renamed a while back to "Enable", so if you're seeing that button lit after you enable your effects, that's correct.
FabFilter effects don't use the Auria preset system - they have their own system built into their plugins.
Rim
FabFilter effects don't use the Auria preset system - they have their own system built into their plugins.
Rim
Re: Effects chain issue
I apologize. I meant on the fab filter itself, the bypass button is yellow.
Who is online
Users browsing this forum: No registered users and 201 guests