Auria mixer and MIDI mapping

For general questions or discussion of Auria.

Moderators: Corey W, Rim

Corey W
Expert
Posts: 568
Joined: Tue Sep 23, 2014 11:58 am

Re: Auria mixer and MIDI mapping

Post by Corey W » Tue Mar 14, 2017 10:42 am

I just tested the setup again, here are the steps I am using

1) Turn on iPad> Turn on Bluetooth

2) Launch Auria Pro

3) Turn on nanoKontrol Studio (To battery mode) while holding down the Scene and Rewind (two arrows pointing left) buttons

4) Go into the Auria Settings> MIDI tab

5) Press the 'Bluetooth MIDI' button and connect the nanoKontrol Studio

6) In the Core MIDI i/o select Receive and Send Remote for the nanoKontrol

7) Change 'Remote Protocol' to Mackie HUI

8) Go back to the mixer screen and test the controls on the nanoKontrol Studio

Qwimby Wun
New Member
Posts: 3
Joined: Sun Mar 12, 2017 2:25 pm

Re: Auria mixer and MIDI mapping

Post by Qwimby Wun » Tue Mar 14, 2017 6:33 pm

Corey,
Thanks for the friendly advice. I followed it closely but my NKS still goes offline 2 seconds after I select HUI. I'm convinced I got a bad one. I'm going to send it back. I have no complaints about Auria Pro tho. It's fantastic.

Post Reply

Who is online

Users browsing this forum: No registered users and 175 guests