Setting an end point

For general questions or discussion of Auria.

Moderators: Corey W, Rim

Post Reply
firehosed
Expert
Posts: 33
Joined: Fri Dec 20, 2013 9:26 am

Setting an end point

Post by firehosed » Wed Apr 02, 2014 11:05 pm

Is the a way to define an end point on a song? I have a song that ends around the 79th measure but when I did the mix down it ran much further than that. Also, when I run to the end of the track it goes far beyond where the music ends. I've tried looking through the user manual and haven't seen anything.

Thank you

pitzipado
Expert
Posts: 144
Joined: Fri Jun 01, 2012 8:45 am

Re: Setting an end point

Post by pitzipado » Wed Apr 02, 2014 11:12 pm

Hello you can set locater points- just to left of transport control then
in mixdown window select "locater range" and Auria will stop the mix at the
locater out point
best of luck- good sounds!

firehosed
Expert
Posts: 33
Joined: Fri Dec 20, 2013 9:26 am

Re: Setting an end point

Post by firehosed » Wed Apr 02, 2014 11:16 pm

Thank you so much

Post Reply

Who is online

Users browsing this forum: No registered users and 133 guests